BNC Connector

Regular price $6.70

Shipping calculated at checkout.

Vertical BNC module based on an "Amphenol" 112538 Drawing
Horizontal BNC module based on a "TE Connectivity" 5413631-1 Drawing

Mounted with a turret connection, 2 through-hole pads, and 1 surface-mount pad for ground and chassis connections. 2 through-hole pads and 1 surface-mount pad for signal connection.

This module is very sturdy when mounted with only 2 standoffs (one in each corner) and extremely solid when all 4 are used.

Footprints for local series or shunt termination and DC block.

Use one of these to connect your project to the outside world. BNC connections are often used in test equipment, RF, and for sensitive signals. Have a sturdy point to connect your project to a function generator or oscilloscope (be sure to properly terminate your cable for best results).

Horizontal version works well for protruding out the face or back of a chassis.

Module size: 1.5"x1.5" nominal (1.4"x1.4" actual).
Mounting holes: 4x #4 screw holes (0.116") on 0.5" grid. 1"x1"
Contents: module PCB with BNC and turrets installed, 1x10uF cap, 2x49.9ohm resistors, 2x0ohm resistor, no hardware or additional components.